7435A REV B Norge Dryer Parts List

Seal, inner cap (o-ring seal)

Also known as an O-Ring. This black o-ring seal is three inches in diameter.

Dishwasher drain hose (drain hose)

The drain hose connects to the pump located below the lower spray arm. It aids in proper dishwasher drainage by carrying the drain water from the dishwasher drain pump to the kitchen sink drain. The drain hose measures 8 feet long. If your drain hose becomes damaged or cracked it will cause water to leak on the floor and you will need to replace the hose. This hose is white and black in color, made of plastic and is a genuine OEM part. Please make sure you shut off the water supply and disconnect the power to the dishwasher before starting your repair.

Upper crisper drawer frame

Frame ONLY. Glass must be ordered separately.

Freezer upper door bin (freezer door bin)

Sold individually.

Valve knob (burner knob)

Sold Individually. This black knob accepts a D-shaped shaft.

Defrost timer (freezer defrost timer)

The defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, the freezer section is too warm, or the freezer is not defrosting, you might need to replace the defrost timer. This defrost timer is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.

Door spring

Sold Individually.

Tine bracket (bracket)

The tine row bracket helps to hold the tine row in place on your dish rack. If your clip is broken or cracked, you should replace it. This part measures approximately 1 1/2” long. The tine row bracket is made from plastic, is gray in color, and is a genuine OEM part. It is sold individually.

High limit thermostat (high limit thermostat (limit: 250-80))

With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 250 degrees Fahrenheit. The element will kick back in when the temperature drops to 190 degrees Fahrenheit. Differential of 60 degrees.

Speed control plate (control plate assembly)

Used in Mixers.

Dishwasher drain pump (pump, drain)

Rubber washer (washer, rubber (2))

The black heating element washer goes between the heating element and the dishwasher tub to form a seal where the element attaches to prevent water from leaking during its cycle. If the washer goes bad it will cause water to leak out on to the floor. This part is made of rubber, measures approximately 1” in diameter and is sold individually. This is a genuine OEM part.

Spinner kit (sprayarm, third level)

The water feed tube spinner is also called the 3rd-level spinner. It is located at the top inside the dishwasher tub. This part works like a little spray arm at the top of your dishwasher that distributes water across the top dish rack to help clean the dishes below. If your dishes are not being cleaned properly, or the spray arm is not spraying water, it could be clogged or damaged and will need to be replaced. This spinner is white in color, made of plastic and is a genuine OEM part.

Power nut

This power nut is intended for use with trash compactors. This part is attached to the side of the ram where it is threaded. When the power screw rotates, it is fed through the power nut which pulls the ram down to compress the trash. If your trash compactor ram gets stuck or does not stop at the end of the compacting cycle, you may need to replace this part. This power nut is white in color and made from plastic. Please remember to disconnect the power to the trash compactor before starting your repair.

Screw

This small, Phillips-head screw works with your refrigerator/freezer. It screws in to the freezer door and connects to the door handle. This part is made of stainless steel and is sold individually. This is an OEM part sourced directly from the manufacturer.